Gutter repair referrals for Denver & nearby townsCall: (720) 868-9072
(720) 868-9072

Drip Edge & Gutter Flashing in Denver, CO

gutterrepairdenver.net

The thin metal at the roof edge and behind the gutter keeps water out of the fascia and in the gutter.

Water running behind your gutters?
Call now to be connected with a local gutter company in Denver.
(720) 868-9072

Drip edge and gutter flashing are thin metal pieces at the roof edge that direct water off the shingles and into the gutter instead of behind it. When they are missing, bent or too short, fascia rots and gutters pull away. Call the number on this page to be connected with a local gutter company in Denver.

Drip edge flashing at a roof edge above a gutter, drip edge & gutter flashing in Denver, CO

What drip edge and flashing do

Drip edge is an L-shaped metal strip fitted along the eave and rake of a roof. It carries water past the fascia board and into the gutter. Gutter flashing, sometimes called back flashing or an apron, bridges the gap between the shingles and the back of the gutter so water cannot slip behind it. Together they protect the fascia, the soffit and the wall below.

Signs something is missing or failing

  • Water stains, peeling paint or soft spots on the fascia behind the gutter
  • Water running down the back of the gutter or the wall during rain
  • Gutters that pull away from the house at the top
  • Shingles that overhang the gutter by too little or too much
  • Rust streaks or bent metal along the eave
Call now to be connected with a local gutter company in Denver.
(720) 868-9072

The Denver angle

Denver has hail, wind and freeze-thaw, and each one works on the roof edge. Hail dents thin metal and bends drip edge, wind lifts loose pieces, and meltwater that refreezes behind a gutter forces its way into small gaps. Older homes in the city's core sometimes have no drip edge at all, and fascia there is often wood that has taken decades of weather.

Roof permits in Denver

Denver Community Planning and Development says roof repair or replacement needs a permit when the work covers more than 10 percent of the roof area or two roof squares, whichever is smaller. Its quick-permit page does not address gutters. If drip edge is replaced as part of a larger roofing job, the roofer typically handles the permit. Ask who is responsible before work starts.

What happens on a visit

A local gutter company looks at the eave from the ground and ladder, checks fascia condition, and decides whether to add or replace flashing behind existing gutters, replace drip edge in sections, or take the gutter down so the metal can be fitted properly. If the fascia is soft, that gets repaired first, or the new gutter will hang from rot.

Repair or replace

Adding flashing behind a good gutter is a modest repair. If gutters are old, dented and pulling loose, replacing them at the same time avoids doing the work twice. For a cost range on new gutters, see the gutter replacement page.

Stay safe

Do not work from a roof edge or a tall ladder yourself, keep away from power lines, and avoid wet or icy days.

Drip Edge & Gutter Flashing questions from Denver homeowners

What is the difference between drip edge and gutter flashing?
Drip edge is a metal strip along the roof edge that sends water into the gutter. Gutter flashing sits behind the gutter and closes the gap between the shingles and the gutter back so water cannot get behind it.
Do I need a permit in Denver to add drip edge?
Denver Community Planning and Development says roof repair or replacement needs a permit when it covers more than 10 percent of the roof area or two roof squares, whichever is smaller. Its page does not address gutters, so confirm with the city.
Why is my fascia rotting behind the gutter?
Water usually gets behind the gutter through missing or short drip edge, open flashing, or a sagging run. Repairing the fascia without fixing the water path means it will rot again.
Can flashing be added to existing gutters?
Often yes, if the gutter and fascia are in good shape. Otherwise the gutter may need to come down first, and a gutter company can advise.

Related gutter repair services in Denver

Drip Edge & Gutter Flashing in nearby cities and towns

Arapahoe County

Jefferson County

Adams County

Douglas County

Broomfield County

Boulder County

Weld County

Elbert County

Larimer County

Clear Creek County

Gilpin County

Park County

Call now to be connected with a local gutter company in Denver.
(720) 868-9072

Last updated:

☎ Call (720) 868-9072